View Full Version : Scope Mount for the Galil

08-29-2005, 09:29 PM
I just ordered a scope mount for my Galil ARM. Scope mount will take any AR type scope.

Will be putting my ACOG on top. I will post pic's and give a range report.

Ordered from:



08-31-2005, 09:14 PM
Thanks for the link to a GALIL scope. But, I don't know if I want to put such a thing onto a gun which may be good for kind of close late evening Coyote hunting. Just about the time they come out looking for your chickens, is when a scope goes black.



08-31-2005, 11:26 PM
Just a note, The originals were made of steel. Early model where slanted rearwards and the 90 degree where later production.

09-04-2005, 05:02 PM
Not good. I just received my scope mount. This thing is a peice of junk. This type of mount is suppose to slide onto the left side of receive, then you move a latch over which lock's mount in place.
The first couple of times I tried installing, the mount looked like it was on wrong, not leveled, croocked, going to the right???? Looks like the mount is made of aluminum. Part of the base of the mount start flaking when I tried again to install. Not happy. I am going to try to get my money back.:(

09-04-2005, 08:53 PM
They are copies made by Leapers in China. They are way off from the originals made by IMI. The aluminums Originaly they sold for $69 a few years back. Althogh, I never got the clone, Get the original IMI. (if you can find them)

09-05-2005, 06:18 PM
Oh well, that is what a MAUSER K98 if for. The GALIL is for faster closer kind of duty.

MUSIBIKE :50_cal

04-03-2006, 01:21 PM
Glad I saw this, I was going to order one.

04-13-2006, 01:34 PM
I have an original IMI scope mount for the Galil 223 ARM and they do look like they are crooked. That's just how they are made. When the scope is installed, you end up bruising your knuckles from the cocking handle.

04-14-2006, 10:48 AM
Tough break dude. Anytime something "metal"(as they describe it) is anodized, it's made from aluminum.