Where to buy Micro Uzi Stock?

[M1A....]

Talked with Vector about a month ago about having a stock & backplate welded on my converted FA Uzi pistol, and they say no problem. And it is no problem, except I found out today, the parts they are using are not original IMI parts. Which is probably OK, except that I would prefer to use original parts. The gun is a bit rare to begin with. It's a original Fleming sear conversion Micro Uzi. Not too many of them around. So I don't want to take a chance of messing it up with aftermarket parts. Anybody know of somewhere or someone who may have some original Micro Uzi backplates & Stocks? I appreciate your help!!!

M1A....:uzi

[BlackBird]

I HAVE ASKED THE SAME THING IN THE WANT TO BUY, CAN ANYONE HELP?:wtf

[Oswald2001]

Does bendavid25 know of a source in the UZI Motherland?

[tacdrivrnc]

I had vector install one...
they didn't have a micro stock but used a modified mini uzi stock.
Same length after all was said and done, just didn't have the covering over the cheek piece and the shoulder piece was from a mini uzi.
also had the bayo lug and sling swivel installed.
I was very pleased.

[M1A....]

I had vector install one...
they didn't have a micro stock but used a modified mini uzi stock.
Same length after all was said and done, just didn't have the covering over the cheek piece and the shoulder piece was from a mini uzi.
also had the bayo lug and sling swivel installed.
I was very pleased.

Could you post a few pics of your gun and their work please?

Thanks,

M1A....

[tacdrivrnc]

here.......

http://www.uzitalk.com/forums/showthread.php?t=17065&highlight=uzi+pistol+carbine

hope that helps

[bendavid25]

here.......

http://www.uzitalk.com/forums/showthread.php?t=17065&highlight=uzi+pistol+carbine

hope that helps

Nice rigs. Dude where did you get the extra long micro barrel? I've been looking for a longer (not that long) Micro barrel forever. I have to have one.:tongue

I will call IMI tomorrow on the Micro stocks.

[tacdrivrnc]

had member barrelxchange make it so vector could do the mods without it being registered as an SBR. About 10" or so is barrel and the rest is a welded sleeve to comply with our ignernt gun length laws.

[M1A....]

here.......

http://www.uzitalk.com/forums/showthread.php?t=17065&highlight=uzi+pistol+carbine

hope that helps

Thanks tacdrivrnc!!

Looks like they did a great job!! I really didn't want to do an aftermarket stock, but unless you really know your Uzi's you can't tell the difference. I definitely need a stock. Went shooting at the range today. I hit the ceiling, and the two other guys that shot this gun did the same!!! Not very controllable without a stock. I'm going to send it to Rex at Vector this week. Thanks for helping me make the decision!

[M1A....]

I will call IMI tomorrow on the Micro stocks.


That would be great Bendavid25. Post a response after you know. I'll hold up on sending this to Vector for a few days. Thanks, M1A....

[emerz]

I will call IMI tomorrow on the Micro stocks.

While you have them on the phone, ask them about mini stocks with the plastic covering on the strut.