About to send my Uzi to Vector

[sigfla]

Well had some fun with it and now it is time to send it off. Will have the .22 installed, semi ramp, and the mag catch fixed. Also, my ratcheting pawl on the top cover doesn't really catch well.

Anything else I should have done or looked at while it is in? The gun functions perfectly except for the mag catch issue.

[RoverDave]

Mike usually checks trunion alignment. He checked and adjusted mine when I sent my Mini in and I never even mentioned anything about it. He also adjusted the way my lower fit since it was near impossible to get the pin out. If yours comes out easily then it's not an issue.

[MuzzleFlash]

Originally posted by sigfla
Well had some fun with it and now it is time to send it off. Will have the .22 installed, semi ramp, and the mag catch fixed. Also, my ratcheting pawl on the top cover doesn't really catch well.

Anything else I should have done or looked at while it is in? The gun functions perfectly except for the mag catch issue. I have had the same problem with the ratcheting pawl before. In my case, the rear facing portion of the wire spring was not square. Taking long nose pliers to it to square it up seemed to fix the problem.

Just be careful. This is a safety device you're fine tuning.

YMMV.