7.62x25 Uzi Carbine Barrel?

[RebelGray]

Wondering if I can get a barrel chambered in this calibur so I can shoot my Tok, my CZ52 and my UZI with the same fodder....

[JClem555]

I do not have a 7.62x25 to verify this with, but isn't the overall length of a cartridge longer than a 9mm, or .45 ACP? I do not know where you would even get a magazine that it would fit in, and then fit into the gun itself after that... With all the caliber conversion barrels around, I am sure someone could make you a custom barrel, but the issue is the magazine. I am not sure you could find a way to make it work.

[RebelGray]

They fit my 41 AE mags just fine :)

[JClem555]

Well, it may work then. It would have to be a custom job though, as to my knowledge, none were ever produced commercially. You might could contact barrelxchange or one of the other guys doing custom conversion barrels and see what they can do.

[barrelxchange]

I've already looked into that one, It is possible to do but that round WILL NOT fit properly into a 41AE mag. Though you might get them in the mag, the angle of the round is too steep, you will have feed problems.

I have talked with Chris Humphries about a mag well conversion using the CZ24/26 mags and magwell from 1 of the parts kits. The biggest problem is that you have to enlarge the mag hole in the receiver for it to work, also you would need to have a new recoil spring made with more tension on the bolt. I am in the process of making some more powerful recoil springs for the 357SIG conversion that I make and that would work for the TOK round, but it is a up hill conversion.

Troy

[Mario_FAMO,Inc]

Too bad, it would be a 'smoker.