Pin for attaching the lower

[RoverDave]

Instead of a normal push pin, my IMI model A came with a pin like this. It has threaded hex bolts in both ends. When I first got the gun, I just figured that IMI had done that to discourage people from putting on a FA lower. But now I'm wondering if it's original or not. What do other people have on their IMI's?

http://myweb.cableone.net/dgaboury/pin.jpg

[ColtShorty]

My Model A has the push pin. I have never seen that style on an UZI before, but I have seen it on a B-Square scope mount for a SKS.

[RoverDave]

The hole is still 8mm so the larger (FA) pins don't fit. I'll need to round up an 8mm push pin to get rid of this stupid thing.

[RoverDave]

I'll have to double check. It's been ages since I looked at a push pin for this gun. But after tearing the guns down several times lately for the pistol photos, I know I hate this dual bolt assembly!

[amphibian]

A guy had a semi IMI MINI that had pretty cool looking 2 piece pin. It looked factory. He said he thought it was a factory pin but not sure. I've never seen one like it. I wish I had a picture. It was not threaded. It is hard to describe. One piece went through the other and was held in because the metal was bent in such a way that you had to push it from the other side to release it. My description probably didn't help any.

[osprey21]

That sounds alot like the two piece pin on a M-11/9. It's basically a 'Tube' with a pin that goes thru it and locks the two together with a 'Lip' that snaps over a ridge in the tube. Here is a pic of the 'Pin'.

http://mac10.org/macpix/m119strip04a.jpg

[bluethunder]

My micro (pistol) has a hollow push pin. Not the threaded unit that you have.