bolt stop removal

[jwp]

bought a spare hebrew f/a 9mm lower for my vector rr fullsize

won't fit

the lower has a bolt stop installed while the vector doesn't and this prevents the lower from installing properly. afaik this is optional and i'd like to remove it.

how does one get the pin out holding the bolt safety in place?

do i need any other parts to make non bolt safety lower?


tia

ps i really don't want to cut on the receiver but is that required for all of these installations?

[amphibian]

Yes, you are required to cut the receiver to use the bolt safety. I personally don't use it.
To remove the bolt safety, you need to remove the grips, take out the grip safety (the grip safety is what prevents those pins from coming out)
I think you may also need to cut the top of the selector off where it stops the bolt safety from going up higher.

Please look at the two links from the library:

http://www.uzitalk.net/reference/pages/assemblelower.htm

http://www.uzitalk.net/reference/pages/boltsafety.htm

[jwp]

thanks, the assemble the lower talks about the grip safety/etc but says nothing about it holding the pins in place and though i've had the vector for several years now i've only taken lower off to put humphries gg lower on for the 45 kit
:D :D

[RoverDave]

jwp, check your PM.

[jwp]

it's out, lower doesn't fit as the pin holes in the lower don't align with the reciever and the pin is canted off center when trying to be installed GRRRRRRRRRRRRRRR!