Close up pics of Micro Stock mounting hardware

[nitro450exp]

Tenngalil,

I would like to mention that I bought the knuckle to mount an R4 stock, the all alloy one with the web between the tubes, It would not fit.
I had to drill the holes deeper before the roll pin could be installed, So I am not sure it was SA.

Thanks
Nitro

[Tenngalil]

You can pull ten stocks apart and swap the knuckles around but less then half will line up.
i remember seeing a stock years ago in a sealed bag with no holes for the pin so i'm guessing they came ready to drill to the knuckles.