New AR15 7.62x39 bolt/firing pin kit
Just letting everyone know that we've released the new kit for 7.62x39 shooters.
It addresses the FP protrusion that commonly is too short with normal AR15 firing pins and Wolf Ammo or Combloc Ammo.
Also, even when filing the tail of the bolt for getting the correct protrusion to ignite the primers in this ammo, it sometimes then had a nasty habit of piercing the primers, because the FP was narrow diameter.
We've re-profiled the firing pin and extended it to make better ignition on the Wolf and Combloc ammo, without piercing primers.
The bolt has a slightly enlarged hole for the new firing pin, so it comes as a package of bolt and firing pin.
It's being tested currently for an article by Jeff Zimba in Small Arms Review magazine, and he really is liking it.
Also, it may be endorsed by Wolf Ammo, and they have expressed an interest in endorsing this for AR15 use with their ammo, but that hasn't happened yet.
Anyway, it's $125 for the package, and we have them in stock.
Please call me if you want one, and I'll take care of it for you.
Photos are not available right now, but when Mack sends me some, I'll post them.
Question I have an unopened bolt I ordered back in June for a build thatís not done yet. Can I send that bolt back? And pay the difference for the new bolt and pin?
Shot at 2006-04-02
I think that would probably be ok.
Originally Posted by beltfed
However, you'll need to coordinate that with Mack to get it done.
Please call him at 207-945-5441 or email him at MGI@adelphia.net
Thanks E-Mail sent
Originally Posted by TWL
Shot at 2006-07-03
Please consider becoming an UZI Talk Supporter.