UZI Talk Forums
+ Reply to Thread
Results 1 to 5 of 5

Thread: Forward grip for stock upper on M10/9 and viper

  1. #1
    Registered User
    Join Date
    Mar 2010
    Posts
    521

    Forward grip for stock upper on M10/9 and viper

    Is there a forward grip out there that goes on a stock PS M10/9 but allows the use of a gemtech viper and locking collar?

    After shooting my MP5k-PDW for a bit, I've decided to let go of my purist streak when it comes to my MAC. Dark day.

  2. #2
    Registered User
    Join Date
    Feb 2015
    Location
    CT
    Posts
    93
    Haven't seen that set-up...

  3. #3
    UZI Talk Life Member

    Join Date
    Mar 2006
    Location
    Southern New Hampshire
    Posts
    1,999
    It would seem to me that a "L" shaped rail could be attached to the lower part of the trunnion above the front pin with enough clearance to install and remove the upper and not interfere with the collar. I would call Practical Solutions and ask Sam about it. I would think that he had dealt with this configuration before. Good luck with your vertical fore grip project.

    Scott

  4. #4
    Registered User
    Join Date
    Apr 2015
    Posts
    253
    For my m10/45 I had a practical solutions ghost upper modified although I think Tina or Sam told me the other ones will work with the front grip and gemtech without issue.



    It had two screws holding on the front grip mount. Had it milled out so I could put the gemtech collar in it and drilled and tapped the 4 mounting holes around the corners.

  5. #5
    Registered User
    Join Date
    Apr 2020
    Posts
    11
    I’m going to have to copy this once my GSL MAC45 can gets approved

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Please consider becoming an UZI Talk Supporter.