Class 3 shooters blow thier loads faster and with only 1 pull of the trigger
Sounds good. I'm going to swap out to the old style sear (the one that came with the uzi) and order the spring retainer. I'll let everyone know how it works out. And order the disconnector stop just to have with the newer sear.
Thanks to everyone for the help.
https://photos.google.com/photo/AF1Q...JNJgnweOuGkFgB
I have replaced basically everything in the grip lower, new sear, new trigger and and still having this problem.
I'm hoping the video displays, its my first time trying to upload a video.
David
Nope, link doesn't work.
Looking for the definitive reference book on UZI history and technical information? Check out my book The UZI Submachine Gun Examined. Details to order a copy are here.
https://www.metacafe.com/watch/12160...fa-in-sa-mode/
http://<iframe width="560" height="3...reen></iframe>
Do either of these work. Thanks
Last edited by David223; 01-18-2021 at 02:51 PM.
No.
https://dai.ly/x7yrypc
This video was uploaded to DailyMotion. Hopefully it works. You will see the problem because the selector switch is in SA in the video and the bolt continues to cycle.
This is a registered FA uzi. It runs fine in FA.
Last edited by David223; 01-19-2021 at 11:17 AM.
Bump to top. Would appreciate any suggestions after looking at the video.
With the bolt out of the gun, top cover off, and selector set to semi, when you pull the trigger does the sear actually trip, and pop back into its upward position, or does it remain held down ?
This is a video of the bolt out, cover off, set to semi.
https://dai.ly/x7yvlt0
I have the top clearance set to 0.005, can't even squeeze a 0.015 guage in there. So I'm hoping the top clearance was just letting the bolt ride over a partially pulled trigger.
I need to get to the range to test all the changes.
Posting Permissions
Reply With Quote