UZI Talk Forums
+ Reply to Thread
Results 1 to 10 of 10

Thread: Uzi fixed stock hardware

  1. #1
    Registered User
    Join Date
    Jul 2007
    Posts
    31

    Uzi fixed stock hardware

    Measurement needed of notch that goes on lug of receiver the width and length(depth)


  2. #2
    Registered User
    Join Date
    Feb 2003
    Posts
    2,220
    That looks pretty beat. Quick detach wood stocks used to be pretty cheap. Like $50 for a pristine one. I much prefer them to the folder, however, they lack the cool factor.

  3. #3
    Registered User
    Join Date
    Jul 2007
    Posts
    31
    Just need measurements folks

  4. #4
    Registered User
    Join Date
    Feb 2020
    Location
    Central Texas
    Posts
    24
    Width is 12.32mm and depth of the cut is 10.95mm

  5. #5
    UZI Talk Life Member
    kanewtervalve's Avatar
    Join Date
    Jan 2003
    Location
    PA
    Posts
    2,212
    I got new wood from Sarco and robbed the hardware off a beater I bought at Apex

  6. #6
    Registered User tonelar's Avatar
    Join Date
    Feb 2004
    Location
    Texas
    Posts
    636
    Quote Originally Posted by kanewtervalve View Post
    I got new wood from Sarco and robbed the hardware off a beater I bought at Apex
    i was looking for a nicer wood stock (mine is beat up). thanks for the heads up.

    also Apex sells stock hardware for $11.
    Last edited by tonelar; 12-21-2021 at 04:35 AM.

  7. #7
    UZI Talk Supporter
    sniperdoc's Avatar
    Join Date
    Jan 2015
    Location
    TN
    Posts
    5,227
    It's amazing what a stock can look like if you spend a couple of hours sanding and refinishing it.

  8. #8
    Registered User tonelar's Avatar
    Join Date
    Feb 2004
    Location
    Texas
    Posts
    636
    Quote Originally Posted by sniperdoc View Post
    It's amazing what a stock can look like if you spend a couple of hours sanding and refinishing it.
    You are right. Ikve seen dents raised with steam. I’ll cut the old stock down to fit a mini.

  9. #9
    UZI Talk Supporter
    sniperdoc's Avatar
    Join Date
    Jan 2015
    Location
    TN
    Posts
    5,227
    Quote Originally Posted by tonelar View Post
    You are right. Ikve seen dents raised with steam. I’ll cut the old stock down to fit a mini.
    Steaming works wonders for shallow dents where the fibers aren't broken

  10. #10
    Registered User tonelar's Avatar
    Join Date
    Feb 2004
    Location
    Texas
    Posts
    636
    no amount of time and attention will get this semi auto version from an smg stock

    again, my thanks for the "heads up"
    Attached Images  
    Last edited by tonelar; 01-06-2022 at 10:07 PM.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Please consider becoming an UZI Talk Supporter.