Search results

Just voted: 23% Yes 77% NO ....... Go Team !!!!...... :buttkick

Rich, Can you post photos of each side and the bottom (exterior) of the receiver? Also, is there anything stamped on the bottom of the receiver? Thanks

Re: Trigger Assembly Conversion From Full to Semi- Hi UZI_SBR_AWC and thanks for the response. I also understand that the rear mounting push pin's diameter is 9mm (0.354") for the semi auto and 8mm (0.315") for the full auto assembly.

Does anyone have instructions for converting a standard full auto trigger assembly to Semi-Auto. Is there a ATF letter describing the modification out there? Thanks

The way I see it... ;) ;) ;) Now, do the "Boys From Brazil" see it that way  ??? ??? ??? A receiver was produced prior to the 1989 ban, it was assembled and test fired and then disassembled for sale AS A RECEIVER ONLY, wouldn't that make it a bonified pre-ban receiver?

Here is one answer While looking for an answer to this question, I ran across this interesting article: http://www.ak-47.net/legal/preban.html Check it out...Interesting reading

Here is a link to a copy of the Group Industries auction inventory.  Interesting reading... http://www-2.cs.cmu.edu/afs/cs/usr/wbardwel/public/nfalist/group_auction.txt

Thanks Cookie...Just sent them a email... UZI_SBR_AWC Don't know...Wouldn't serial # be enough to document pre/post ban?

I've been offered a Group Industries receiver with these markings: HR4332S 9mm/45ACP/22 GP Ind Lou KY 40214 On the other side is the serial # 5091xx Is this a pre or post ban receiver ???  ??? Thanks

Amphibian..Why not send those diagrams to "Cookie" so he can post them in the reference section??  Thanks  ;) ;) ;)