Search results

^ I’ll admit I didn’t watch the video as I’ve seen their schtick before. From what I’m gathering that one seems legit, but I won’t be watching any of their videos, you do what you want. That said, I replied to something I felt was getting confrontational, so be it I said newb. Your sharp...

Yes. 9mmA had the revisions. The final version that’s rare has a dot instead of a dash between the cfw-9

Practical Solutions can correct the 9MMa issues. I know of a bolt that was sent to him directly when purchased (used) before it fired a single round with the new owner. It might work well for you with your upper, won’t know until you try it.

I posted this in a previous thread. Pasted it here: The main one is where the cartridge sits on the bolt face. If you had an empty case with no primer installed and sit it in the pocket you’ll see the case doesn’t sit flat. The bolt face is cut too tight. That dimension was opened up on the...

I didn’t call them a fraud, newb. They haven’t committed a crime. I’ve done my research, if you don’t want to do yours, or don’t believe me that’s fine. Making you happy chasing your request(s) isn’t something I care about, at all. Anyone observing their playlist previously on a basic note...

Do your own research.

Fake. They purposely buy guns just to weather them fast and act like it’s some barn find restoration. I won’t feed their channel with a single view.

I love it when a plan comes together.

Modded PAM2 mags

In 2015 Clyde Armory had (2) well-worn 9mm M10s for sale with Atlanta PD electro penciled and had shot-out silencers marked the same. Price for the M10 was $4k. Clyde is known to buy/sell surplus LE equipment. I passed on the M10s and bought a minty M11/9 from another seller for a little more...

Don’t have pics but here’s a vid of the welded mag.

I use PAM2 springs in my 30rnd Zmags. Direct swap. The wire is thicker and it’s like +10% length. Brute spring power makes my 30s something I can forget about. I welded a 50 & 30 together and used a 3d printed junction for the springs to push against each other. It’s a crazy long magazine and...

The lower markings look laser engraved like the new CR series Colts.

Samson makes a repro shorty ac556 sight in blued as well. This link is a supporting vendor here. https://www.robertrtg.com/store/pc/SAMSON-AC-556-STYLE-GAS-BLOCK-FRONT-SIGHT-FOR-2007-AND-EARLIER-MINI-14-30-STAINLESS-p12845.htm

Haven’t seen many for $500 lately. $750 is what I see selling, most are listed for much higher but the sit forever.

Just a note I find +1.5% is what I scale from a CAD file to the Cura slicer when casting aluminum from a 3D print. Don’t want to derail this thread, just pointing out my findings on what I said.

Basically that some guns imported as pre-86 dealer samples were deemed by the ATF to be transferable. That means a chunk of samples are now added to supply, and holders of those (previous samples) now have something worth considerably more as a transferable.

Typo, probably 129 for an old school 9mm can with big volume and a wipe. New stuff 9mm just baffles is in the 120s range. Rimfires are in the teens, so doubt the typo is 119

Awesome 🇺🇸 Rare surprise

I agree with leaving it alone. The tabs get egged mainly when the bolt slams home on an empty chamber. The sear/selector pin holes egg too, mainly each time you let off the trigger and the bolt engages the sear. With an empty gun, while looking at the selector switch… pull/release the trigger...