Search results

I would buy a full size with removable firing like the original.

Here you go.

OEM M11/9 fits nicely in a PM 63 rak canvas holster but you have to take off the front strap bracket.

How much indentation are you getting on the primers?

These bolts will run in a M11/9 but there are a few issues with the spring not having enough room too fully compress inside the bolt. They are not going to mention this. It is the best available option for slow fire in original configuration. If it were slightly longer it would be perfect for...

Has it continued to fires after you release the trigger?

Eddiep could tell us the spring set up used in the video?

Don't let a couple of jackasses get half your army killed.

If you shoot unsuppressed with 115 grain wolf with 107 coils it will hit the coils occasionally if you shoot suppressed with anything but weak reloads it going to be all over the spring. I've tested this extensively with different types of ammo and different coil counts trying to get the A bolt...

Yes it does bottom out on the compressed coils and does damage them with the springs Vegas sent with the bolt. The ones with orange paint on one end. 107 coils with a wire diameter .040". If you clip enough coils for the bolt to hit just one recoil pad it shoots below 600 rpm. And Im not sure...

Is there a list somewhere for interest in another run of the full size W bolts. My A bolt is better than nothing but I would sell it for a full size or buy a full size even if I couldn't sell it. In my opinion the perfect weight is somewhere between 30oz and 27oz for the M11/nine. But make them...

I stack three of the of the plump black type buffers to keep the spring from getting abused. The bolt hits the buffers with hotter loads barely. There is room to make the spring pocket a little deeper maybe get down to two buffers . Using the full orange spring Vegas sent with the bolt. The...

If you use the A bolt I would install the rod and compress the spring all the way to see if the bolt hits the buffer. On my max11 sk I have to use three recoil buffers or the bolt bottoms out on the compressed coils before hitting the buffer. Max11 k may be different.

With the ATF acting the way they are and the progressive liberals determined to prevent their subjects from being able reject their tyranny I decided to get the Max11/15 while I still could. Just in case the good old days are coming to an end. I've shot thousands of rounds of 9mm and 22...

Thanks.

The barrel is tight and pinned. I do think it is as it was from Cobray.

How can I adjust barrel alignment? My OEM upper is not closing on the rounds with my CF -W9mmA bolt. It will close if you slam it but gets jammed and leaves marks on an empty case head the barrel needs to go up.The bolt works fine in all other uppers and the OEM works with the OEM bolt. Can it...

Perhaps your adapter could be altered to be a legal accessory for my semi-auto m11. My semi-auto m11 would love using AR uppers.

Ok I've only used wolf and winchester white box both impact the back. It's not a31a. No vbs it's just as it came from Lage it has a 1 13/16" plastic block in the back end. The spring seems weak to me. When I take off the c clip from the guide rod it extends only a quarter inch further. I was...

Does anyone know of a source for a stronger recoil spring for the Max11/31 mk2? I never shoot my max31 upper because the bolt impacts the rear of the receiver. Just doesn't have that smooth recoil like the tungsten bolt uppers. Any suggestions?