Search results

Just a bump for anyone else...

...and there it is. Thanks. Exactly what I was looking for.

Good info there, but it didn't really address my question. I thought I had written two questions, but I really was only scratching my head out loud about the stop dog. In playing with it, I can see that the disconnector does not 'pop out' when the trigger is pulled with the selector in semi...

I just bought one of these, and was noticing its different than other grip assemblies I've seen. The first thing I noticed is that it's missing the 'stop dog'; the little chingadera that sits in the center of the sear on the sear pin. Is that part optional? At first I thought I got a grip...

I'm not the worlds foremost expert on Uzi's, but mostly. The grip assembly for the mini and the full sized Uzi are a direct swap, and are generally identical (with open bolt and closed bolt variants) The sear itself is the only real difference (between open and closed bolt). The grip assembly...

I sent an Uzi pistol some parts to Richard about three years ago for a micro conversion, and he was never able to work on it. I saw on Youtube (don't remember where I saw it) that the family was working to get peoples guns back to them, but nobody has contacted me about my parts. The BWE web...

Holy crap those are great, thanks. Those even appear to be similar, or exactly the same as the mini slings use. I was looking at buying some Israeli rifle slings, and cutting the hooks off at $22 per sling. Thanks again.

Where are y'all getting the clips to attach the slings to the mini/micros?

I ordered a few, and went back from more and they were gone. Hope everyone got a few.

Bullpups are fun when you are looking for something different. It's interesting to me how the manufacturers try to solve the problems they create when making a bullpup. None of them have quite achieved 'as good as' (in comparison to an M16), but they are getting closer. I really wanted an M17...

I do. Give me a few days and I'll get some measurements. Whatcha makin'?

That's a semi-auto rifle in the gunpartscorp drawing.

DSA has them for $75.

I cut a 16 inch barrel down to bayonet size for my mini. I'll do it for my micro, too, if I can find a barrel. You never know.

I'm going to at some point, but haven't yet. The bolts look the same, except the pro bolt has a hole drilled in the left side for the charging handle. If you want side cocking, you're going to have to drill a hole in your registered bolt. It looks to me the bolt could then be removed from...

Cool gun, and great vids.

Not sure what you are trying to accomplish, but it sounds complicated. More complicated than it needs to be. Most people who do this use a threaded barrel, and thread the suppressor directly to the barrel. Those that want a handguard to cover the suppressor get a long handguard with an inside...

Not an expert, but here is my take: 1. Yes. A closed bolt recoil spring assembly with the striker spring removed should work. 2. Yes, but it's not hard to put put a sear with both feet in, which will more symmetrically hold the bolt open and be better in the long term. 3. I've never seen a...

It's a movie gun. There was a time when AKs weren't available, and Valmets were. What would make that gun cool is to figure out what movies it was in.

Most people who kit-bash micros are going the opposite way, putting a side charging bolt in a vintage micro to gain a place to mount an optic that does not interfere with the charging handle, but I would say if you really want is an Uzi pistol (or Micro Uzi), buy that instead. A micro top...