Search results

its going to be either the trip or the little catch on the trigger, or a few other things. Just take a pic so we can help

Let's see it!

CLP and Balistol both have a crystal clear suppressor cleaner fluid. I asked them seperately about if it would clean out 1/2" thick deposits inside the can. They both say that it will. It would be super scary if that was true. Pretty sure its BS The dip wont fix that sort of buildup. I...

Might be an improvement, but I'm used to the thumb mag release by now

the drums are the best part

Vette?

right, but the sear interface block is going to have to be removeable, ridgid, and super light weight to keep the 22lr pitiful recoil energy working

cone breech and m16 extractor were amazing for the platform just irreparably heavy

sure would be more comfortable that way.

I prefer the idea of a dead trigger over additional capturing of the bolt. if the mag follower could disengage the trigger quickly enough, the bolt would be held open and the shooter could continue squeezing the trigger until realizing he was out for me, it would be insufficient to have the...

surely the first few sight radius comments were a joke......however later, still acting like the charging handle was a rear sight

Bummer Tom was a great guy to talk to and deal with. I'm shocked he is gone

I also wouldn't buy these. They could call it mg, but these are not open bolt. It would take a lot to get this to fire 2 rounds in a row. More likely they would determine that these are both title 1 and marking deficient

definitely doesnt fit m10. looks like closed bolt 9 for the ar with no mech to trip the sear. the very rear sheet metal is to cover the transition to the rounded buffer tube. that pick up on the bottom of the bolt looks wide, like maybe for a double feed mag

the 9mm one runs great but is weird. the 22 never ran and was never released. The american 180 upper from tac inc is the one that should have been produced.

Regular old unmarked cfw is 32.5 with the spring and rods

118gr cast, coated hand loads, 5.3 GR WSF. It's not weak. Might be pushing the bolt back further than wwb Usually faster with a can, but I was trying to eliminate variables

I tried the amazonians kit. Dropped my rof from 609 to 571. Still choppy to me. I like the cfw-a in there better but it's an expensive way compared to this

he said his Daughter had to go into the hospital in mid july, then no response

the sk uses the upper section that would have been the bolt weight for a non reciprocating charging handle return spring mech since it cant ride the cf bolt so the sk is still the same size as the k also either the k or sk allow the use of light , laser rails if you wanted such. no such...