Search results

Rest in Love Tom Like many of you, I bought several CF-W tungsten bolts from Tom. I never met him in person, but spoke to him over the phone and could hear the energy and enthusiasm about our subgun hobby. So sorry to hear the bad news. Rest in love Vegas SMG.

I also received the two Cobray shirts that I ordered. They are awesome! Thanks a lot and I really appreciate the stickers too. Nice touch.

Thanks Eric for your response and for sharing the video. What you experienced in that video is exactly what is happening to mine. At first I thought maybe I didn’t reassemble the bolt back properly after my last cleaning but upon inspection, the sear plate does seem parallel. I stripped the...

Thanks Richard. I can always count on you for help and advice and I love all of the many uppers I purchased from you. If I recall correctly, a few of the failures occurred on the first round. Stupid me never thought about adjusting the gas since on two other occasions it ran flawlessly. I...

I used 4 different P-mags and a 60 round American Tactical German made Schmeisser.

I took my Max 11/15 IRM version to the outdoor range yesterday and the first two mags ran fine then after that I started getting failures to feeds about 20% of the time. What would happen is that the bolt would go forward, catch a round, and then seem to drag on the top of the Magpul mag and...

Shit, I should have been buying Suomi drums instead of stocks. :@(

Could Zane put those skills to use and create a limited edition series of T-shirts? I’d buy.

Thank you. I also received mine yesterday. Thanks so much!

Paypal Sent. Thank you!

Thanks for feedback. Sounds like there isn’t much room for adjusting.

Strobo32 suggest 63-65.

I searched all over the forum but couldn’t find any info on this. I have a SWD M11a1 with a large magwell and want to run my CFW A bolt and shoot 9mm in my Practical Solutions side cocking upper. The CFW A bolt came with a recoil spring that measured 8-7/8” long with 89 coils. It seemed pretty...

That is too Funny!

I wonder what’s taking so long? I bought an M11a1 which was delivered to my FFL and initiated a Form 4 on 12/26/18. The Fm 4 was approved on Sep 8. Mine took 8 months (and that’s with a government shutdown).

Because that’s where the holster is?

Who sells those?

No. Its right handed. It’s a pic I took from the mirror in my bathroom.

Thanks everyone for the feedback. I ended up putting a 9mm barrel in the stock .380 upper. Shot it with Blazer brass 115 grain 9mm ammo using the CF-W A bolt I bought from Vegas. It shot fine but there were a few FTE’s where brass got caught between the bolt. Not sure if a larger ejection port...

Zombie Killer