Search results

He told me to ship it back. So I’m doing that.

That does appear to be correct. I apparently bought this one: Instead of this one:

Thanks. I might go that route if US Machinegun isn’t responsive.

Well, first a huge thank you to StenAtopia for spending his valuable time on a couple of calls with me to go over this and troubleshoot it from multiple ends (bolt, upper, and lower). As JwestAK speculated above, I'm pretty sure I was sent a semi-auto upper that has no relief cuts for proper...

This is as far back as it goes (which does appear to clear the ejection port)

Here is what it looks like

Here is what it looks like

I tried that, though it’s not a solid plate there, rather two bars with a gap in the middle (I assume this provides clearance for semi auto components maybe?). I did put a very slight bend on both sides, but it didn’t seem to have any effect on either bolt tightness or ability to lock open.

Nope, it was definitely off and the charging handle was in the unlocked position, unless it can be put in wrong, so when it is oriented with the notch not blocking the sights (firing position) is really locking the bolt. But the bolt opens until the cocking handle is just in front of the handle...

Well, rather than continue to beat my head against the wall, I'll ask here and risk looking really stupid (or more stupid than I already appear). So, I got the FTF Industries bolt assembly for my transferable PS M10/45. I also got a basic top cocking upper from US Machinegun. When I put those...

What lower do you use for your super safety? I’m thinking of throwing one in my Omega OM9 or maybe picking up one of the new AP5SDs and doing the barrel swap

Thank. It’s been a while, but I’ve managed to come full circle and ended up back in an M10/45. I guess it was meant to be.

Good call. I went ahead and ordered their standard top cocking upper.

I might have partially answered my own question. Looking closer at the upper, I see the charging handle doesn’t appear to be the same as, say, the Practical Solutions non-reciprocating one. It looks as if Velocity has put a charging handle hole/slot on both the top and side of their bolt...

I traded into a PS M10/45 lower, but it came as a bare lower. It’s been a while since I had a MAC and I didn’t realize how scarce and expensive parts and mags got. I’m on the list for a Versa 10, but in the meantime, I’m trying to throw together a stock-ish build. I found 2 mags (and who knew...

So the Versa 10 can be swapped between .45 and 9mm? Or is it just two different variants? What mags will it be using for the .45 option? Grease Gun? UMP? Also, how does the barrel and bolt swap work? (assuming you can do that)

@m11stuff@hotmail.com any plans for an MP5 mag well? I’m sitting on loads of the suckers.

ScottinTexas, did you ever sell your drum? I've got one that I'm thinking of selling, but I have the same question about value.

Man, I haven't been on this site in a while. Anyway, I own 3 Omegas, an OM-9 (MP5), an OM-9K (MP5K), and an OM-9SD (MP5SD). The OM-9 and OM-9K run well (though I did have to send my OM-9 back for repair due to an issue with how the mag was seating, but Atlantic and Omega turned it around very...

You need to be careful on how you proceed, if you want to "start with a Saiga". If you want it to be an actual upper and not create a new Post-sample non-transferable, you can't start with a title 1 firearm receiver. It will run into the same problem as the XMG and a few other uppers that were...