Search results

You don’t need it to run?

Compressed springs don’t wear them out. It’s the act of compression decompress that wears.

Magwell would have no impart on it

Would Suomi 36 rd stick still work that were converted for the m10/9? I can’t recall what all was converted

The 40rd American ones pre ban are the bomb

I’d be down w that. Is there a v12 w gg?

You have the closest thing to an mp7 ever

normally I’d say Glock but I hate sf and after watching evo, unless we get mp5 that’s the one

Did you convert an Ac556?

What about the firing pin. Is it just a longer one that when the bolt locks and the carrier moves forward, it’s so long it protrudes?

Well that’s the easiest to load df. And I have 10 rare 40rd American made copies

I’m confuse bc ftf is a brand and an abbreviation for fail to feed

Honestly it’s a mg. You don’t need an expensive one like an EO tech. However I am one to think you don’t put a cheap sight on an expensive rifle. (But this isn’t a sniper rifle) Having said that, aesthetics to me dictate a squarish sight esp w Lage upper. The acro is expensive, holosun 509...

Get the suppressor attached one

Installed. A little thicker. I’ll see if I prefer

They don’t make a 9mm bolt for the A1, except the tungsten one. Hotter ammo will run faster as well.

Ribbed for your pleasure

Paperweights. I’ll properly dispose of it for you. Save the environment

Also does it in any way reduce trigger pull? Might be a dumb q

Does this have to be “adjusted” or fitted