Search results

  1. E

    What do I have? Looks like a Galil SAR, but..

    I bought this recently, and yes, it is FA.. all the parts seem to be a legit SAR, except the fact that there is a bipod attached to the thing. Note there is also a bayonet lug. And, the receiver markings are (at least for my layman eyes) rather non-standard. There is a stamp on the barrel...
  2. E

    8mm Nambu Reloading

    CH4D had/has dies. Yes, they can be made from .357 SIG but there's some trick involved pushing the cases a bit deeper in the die as normal to size the base of the case sufficiently. Try https://www.buffaloarms.com/8mm-nambu-brass-prop-hs-str8mmnambu.html for factory cases from HDS. If you must...
  3. E

    UZI Picture Thread

    Here's the boys.. plus the suppressor (90s era B&T) Closed bolt Mini "Run of the mill" Hebrew markings and the can
  4. E

    Pls help ID this magazine

    Thank you!
  5. E

    Pls help ID this magazine

    Hi all, gunshow find, it's a 50rd mag, just not for an Uzi. Not full size, not Mini. Any ideas? The mag catch cutout sits too low, but not by much. When I pull the bolt back it seats, but then the bolt is blocked by the mag body. No markings other than the round count. Thanks for your help...
  6. E

    B+T is at it again!

    I bought the kh9 some months ago and processed about 600 rds so far thru it. After about 500 the firing pin broke, and b&t sent me replacements in no time. I got them from the manufacturer directly, since I live in Switzerland. Mag well change takes some time and tools so it cannot be done on...
  7. E

    Hello, I have sent you an email via your website a couple of days ago asking about the...

    Hello, I have sent you an email via your website a couple of days ago asking about the possibility of shipping an Uzi mount abroad. Just thought I'd check whether you received it and if international shipping is possible (to Switzerland). I couldn't find any info on your shipping there. Thanks...
  8. E

    Fab Defense UTR Tri-Rail

    I recently installed the very same on my IMI full size. It was hard to get on and certainly no slip on but gunsmithing was not required at all. A rubber mallet was all I needed. Fits tight and no rattle. Not even a 5 minute job. Sorry you had that kind of problem.
  9. E

    UZI Picture Thread

    A Swiss-sized Thanks for the welcome :) Nope, no file-to-fit. Like a glove you gently put on with a rubber mallet :) It's a very tight fit but I didn't need other tools other than a hex wrench. Sorry for the blurry picture, my camera broke and I had to use the cellphone.
  10. E

    UZI Picture Thread

    Me too.. finally. It's a rather old one, IMI with hebrew markings, open bolt. It needed a couple replacements for worn out parts, then I had it it coated with the same stuff they coat the MP5's with. From rusty to awesome. IMHO. ;) http://y16i.imgup.net/20140803_1a9fa.jpg...

Please Visit our Sister Sites Below

Sister Board - Sturmgewehr Sister Board - MachinegunBoards


Please consider becoming an UZI Talk Supporter
Top