Search results

try the website!

Thanks guys !

your link doesnt work

Years ago somebody offered a red dot mount. Anybody know of one now?

Where can I get a spare parts kit for my model B. just springs firing pin etc.!

I always number my mags on the bottom so when I have a problem I know if it is a mag problem or a gun problem!

I have now shot the gun several times after storage, problem seems solved, tight cover. Thanks rcbif

I simply put the middle on a pliable rounded surface and applied pressure to the 2 ends to Bend it. I would not "tweak " it unless you are having issues !

I checked my clearance and it was barely .005, I tweaked it and it is now .010 - .011! I only had time for 75 rounds at the range but it functioned 100%!

That sounds about right, older springs will take a set and get shorter use them!

Its supposed to warm into the 40's tomorrow, I will check the top cover and go back to the range for testing!

I brought some .005 and .010 feelers home from work to check the top cover, what should the clearance be?

It was cold and as the post says no grease was used

I went to the range yesterday and on my third shot I pulled the trigger and no bang! I had seen this before with this gun after not shooting it for a while ( storage 4 months ). I gently touched the charging handle expecting the gun to fire and it did ( expecting from past experience ). The gun...

According to your posted measurements it is twenty thousands too big ( .020 ) and should not be sanded down. Bring it to a machinist friend, local shop or trade school to have it properly turned down. It is not a big job! It will need refinishing also.

I like the idea of shooting the crap out of it and it seems the ammo supply may be loosening up. I am also not using grease anymore and will just use the Millitech!

Thanks for your reply. I will check that out, but it only seems to happen after the gun is stored for a while!

Ok, I sprayed everything down w/ brake cleaner, re-lubed with Millitech and went back to the range. I fired 150 flawless rounds. Still don't have any answers.

I am having a problem where my IMI Model B will not fire and then as soon as I touch the bolt to open the chamber it will fire. Wakes you right up if you were not already. I know there is a close tolerance under the top cover, would using grease there cause this problem. I have thoroughly...

After doing some research it looks like the RTG mount may work for the DeltaPoint, it is similar to the BURRIS.