Search results

The Florida law says "to mimic automatic weapon fire" which would exclude actual full auto devices.

Here's the ones I ordered from McMaster for a full size Uzi. These matched the size of a rivet I had from US Barrel Shroud. Same size for the Mini, not sure about the Micro. https://www.mcmaster.com/catalog/131/3802/97387A207 Part number: 97387A207

My father's receipt from 1984. $495.00

I used the standard CMMG firing pin when I did it and it worked fine.

The video is not showing but you have to move the sear plate and sear plate clamp to the CMMG bcg. And a radial delay barrel of course.

One of these I assume:

That was added later. Seller must have been getting some warnings about that bolt possibly being a unregistered conversion.

I like to have some of these parts but I don't know about that bolt. https://www.gunbroker.com/Item/1077940072

Are these shipping from Vector?

I have a Norrell and M16s with 22kits. The Norrell runs the best. It’s great with Ruger and High Tower magazines. Never had luck with drums. The M16 kits run well but none of them as well as the 1022. I’ve tried the Ceiner, CMMG, Bore Buddy and many different magazines. I even tried an open...

I've had a Norrell for years and I'm just now learning that it has a ball detent!

That's not mine in the picture. I'd like to get one too but I recall them selling on GB for crazy amounts.

This one?

I found this picture of the bolt and buffer on some obscure Uzi forum.

It wobbles a bit but works great and easily inserts into the magwell. The sights are from Lage.

Here’s the original Strobro adapter. It still works great.

U00003XX Early one with no stock/brace mount on the back.

Textured is now available.

It's for a Mini Uzi First Responder. https://www.uzitalk.com/reference/pages/article_firstresponder.htm