8mm or 9mm, what would you do?

[KYGun]

So, I've got a converted from full to semI uzi lower that has the 8mm hole. My new semi receiver to lower piece has a 9mm hole. Would you drill out the 8mm to 9 on the lower and buy a 9mm pin, or make a sleeve for the 9mm hole in order that the 8mm pin work?

 

[SecondAmend]

I bought the sleeve from BWE Firearms which is an UziTalk Industry Member in the Vendors Forum below.

MHO, YMMV, etc.

 

[KYGun]

I bought the sleeve from BWE Firearms which is an UziTalk Industry Member.

MHO, YMMV, etc.

I appreciate your direction....

 

[chipster]

I have 1 of the sleeves from BWE and it's worked great when I want to run SMG style 8mm lowers on the 9mm pin hole group ind receivers.

 

[brazos609]

PM me your address and if I can find the 9mm to 8mm sleeve I had I'll just send it to you.

 

[glockman]

I didn't drill it out, but I acquired a drilled out lower, and it fits like a glove on my semi receiver. I wouldn't attempt it without a drill press though.

 

[mmi]

the advice i got was to take a 223 case and put it in the receiver hole and hit it with a hammer then take a Dremel and cut off the two sides flush . then use a 8mm pin . it works great and is cheap .

 

[MGMAN45]

9mm drill bit 5 second fix

 

[MGMAN45]

No drill press needed

 

[scottz63]

I would drill the lower for 9mm and be done with it.

 

[Ulwembu]

I drilled out the holes in the lower.

 

[MGMAN45]

Place grip body on wooden deck drill with hand drill on one side flip over and do other side.Use your foot to hold in place while drilling.LOL Really Im serious.

 

[KYGun]

the advice i got was to take a 223 case and put it in the receiver hole and hit it with a hammer then take a Dremel and cut off the two sides flush . then use a 8mm pin . it works great and is cheap .

That sounds like my style, lol. I'll do it proving I don't find a sleeve....