Any Interest in Sterling Scope mounts? Ctext

[CLC]

Thinking of doing a run of 6" rail mounts for Sterlings. They would fasten without alteration to the cooling holes on the barrel shroud and allow installation of dot scopes. I should be able to mount them low enough that they would not obstruct the factory sights if an optic is not installed (can't promise that one just yet). If I can keep the cost down to $75.00 or so, is there any interest? How about shorter rails for lasers, vertical grips, etc?

 

[drw]

I would be interested if the design is acceptable. The mount must be stable and secure and allow the removal of the barrel without removing the sight base for me. Post some pics or a drawing or better yet, send me a sample for T+E.

 

[class3JB]

Sterling sight mounts

If its a good design I'd also be interested, I'm converting my sten to a sterling and am old enough to need sighting devices. Good luck JB