FYI Galil Arm/AR Cheek Rest Solution

[dedkin]

Some FYI for any one interested. After searching for an original IMI cheek rest for the offset scope mount set up and with no luck I came across the ICS ICAR Stock Adjustable Cheek Rest 37 for the Galil airsoft rifle. Was informed that it might not work but for under 17.00 shipped I figured what the heck. After it arrived it installed in a couple of minutes without any modification or wear concerns to the stock. It looks good, blends in nice, clears receiver when folded and will adjust up and down in seconds from flush to about 1-1/2 inches high by pulling the spring loaded bracket on the right and choosing your position. Gave me just enough up and out to 10:00 and solved my cheek problem and can still use iron sights with it adjusted all the way down. Also works for over the bore mounts. Over all a good buy for the money.

 

[RSR]

I purchased one of those too. I think it's certainly serviceable but haven't mounted or run through the paces.

What scope mount are you using?

 

[dedkin]

I purchased one of those too. I think it's certainly serviceable but haven't mounted or run through the paces.

What scope mount are you using?

Mount is a ProMag PM 246 with Warne 1 Inch Low Maxima Fixed Rings. End results are 1/4 inch clearance at hand guards and 1/8 inch clearance at rear sight block using a Nimrod scope.

 

[RSR]

Interesting. I have a promag mount but it doesn't fit (too wide) for both my cnc warrior and gln golani receiver scope cuts... Thanks for sharing. Looks great.