Mag adapter modification
- Thread starter Matt41
- Start date
UZI SBR AWC
Well-known member
Pics
Go back to the AR15 thread, titled Hy-tech fitting... I updated it last week, added some pics. I like you am challenged by lack of pics to go along with the text. All work was done with a 8" flat lathe file from Sears and a course 5/16x8" rat tail file, though small finer cut chainsaw file might tak a bit longer, and look nicer, but you just want to open the radius to allow radius on mag' rear corner to slide in.
Go back to the AR15 thread, titled Hy-tech fitting... I updated it last week, added some pics. I like you am challenged by lack of pics to go along with the text. All work was done with a 8" flat lathe file from Sears and a course 5/16x8" rat tail file, though small finer cut chainsaw file might tak a bit longer, and look nicer, but you just want to open the radius to allow radius on mag' rear corner to slide in.
Last edited:
- Status
Please Visit our Sister Sites Below
Please consider becoming an UZI Talk Supporter