Seven Clicks Up
Well-known member
This one seems to be a two piece affair. It’s split horizontally. If I depress the plunger, and turn the sight between the cutouts, I can spin the top part with my fingers. It doesn’t unscrew.
Also, it has a hole in the top, and a hole just below it on the horizontal plane.
I’ve looked in Dave’s book. I haven’t seen another like it. The two tiny holes are connected inside the sight “tower.”
I might add that this isn’t a cut down receiver.
It’s an IMI NMH. Mini receiver.
The hole in the top of the post is 6mm deep, and the hole in the side is 2.5mm to center from the top.
Also, it has a hole in the top, and a hole just below it on the horizontal plane.
I’ve looked in Dave’s book. I haven’t seen another like it. The two tiny holes are connected inside the sight “tower.”
I might add that this isn’t a cut down receiver.
It’s an IMI NMH. Mini receiver.
The hole in the top of the post is 6mm deep, and the hole in the side is 2.5mm to center from the top.
Last edited: