Uzi mag conversion for Semi

FAST996

Active member
Feedback: 0 / 0 / 0
Joined
May 7, 2005
Messages
28
Hello does anybody know who can do this mag conversion besides Practical Solutions .They can do it on SMG'S but not Semi 's because of state law.

If any class 2's out there can do this for the mac10 9mm semi
please post info.

Thanks,
Fast
 

UZI SBR AWC

Well-known member
Feedback: 4 / 0 / 0
Joined
Dec 27, 2002
Messages
2,092
Location
Troy, Ohio
.

EDIT -- I mis-read. You said going to Uzi mag. I think Sam is the inly person doing that to double feed MAC 10-9


There is no real source for the magwell, other than Chris Humphries, who has been doing the M3 conversion. Contact Chris and see if he can set you into a std Uzi magwell that he removed,
 
Last edited:

FAST996

Active member
Feedback: 0 / 0 / 0
Joined
May 7, 2005
Messages
28
Uzi mag well?

Thanks for the info, do you have a contact for Chris?

Fast
 

UZI SBR AWC

Well-known member
Feedback: 4 / 0 / 0
Joined
Dec 27, 2002
Messages
2,092
Location
Troy, Ohio
See the "members" button at top of page, go there, then look for Chris Humphries (spelling?), you can message hinm from there or e-mail him.


I sent somebody to him a while back, and they was able to get a "take-off" Uzi mag tower real cheap.

If your gun used zytels, your option is Sten or steel mag.

If you gun used the double feed mags, then Uzi mag be good to go.

Just match the bolt to mags used, single fed or dual feed.
 
Status
This thread has been closed due to inactivity. You can create a new thread to discuss this topic.

Please Visit our Sister Sites Below

Sister Board - Sturmgewehr Sister Board - MachinegunBoards


Please consider becoming an UZI Talk Supporter
Top