UZI Talk Forums
+ Reply to Thread
Results 1 to 2 of 2

Thread: Folding an Uzi flat???

  1. #1
    Registered User
    Join Date
    Dec 2020
    Posts
    1

    Folding an Uzi flat???

    Has anybody had any success with folding a Uzi flat?

  2. #2
    Registered User
    Join Date
    Sep 2004
    Posts
    693
    AFAIK the only successful bend of the full flats was this guy back in 2013:

    http://www.uzitalk.com/forums/showth...McKay-uzi-flat

    Good results, rather complicated bending die to get the rounded front trunnion area contoured properly. He was going to make and sell benders, then disappeared in early 2014. Most folks here, if they bend one, cut off the front to match their OEM trunnion section, do the relatively simple square bend on the rest and weld it together. Since bent "repair sections" that are complete except for the front trunnion area usually cost less than a flat...

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Please consider becoming an UZI Talk Supporter.