UZI Talk Forums
+ Reply to Thread
Results 1 to 3 of 3

Thread: Can Someone Measure an M11/9 Zytel Mag for Me?

  1. #1
    Registered User
    Join Date
    Jan 2006
    Location
    Florida
    Posts
    73

    Can Someone Measure an M11/9 Zytel Mag for Me?

    Wondering what the measurement is front to back. And does anyone have engineering drawings of the M11 mag well? Wondering what factory spec was. It's not in the Mac Man book.

  2. #2
    Registered User
    Join Date
    Sep 2012
    Location
    West Coast
    Posts
    125
    I got 1.374"-1.375" from a few unused ones.

    EDIT: The issue I had with first run Z-mags in two 1985 M11A1s wasn't front to back length, it was that the narrow end of the trapazoid cross section was too wide. And rust in a matter of days after receiving them.
    Last edited by Rob1928; 02-26-2021 at 12:40 PM.

  3. #3
    Registered User
    Join Date
    Jan 2006
    Location
    Florida
    Posts
    73
    Thanks! My deepest one is 1.372 so they should work. I got 4 that work with no issues and two I've modified by taking just enough off the back so they slide in. Only takes a minute or two with a table top sander. So I think I'm going to keep the other 8 as delivered. I can see where my mag well is a bit out of whack where the two halves come together in the back. One is higher at the bottom of the mag well and the other at the top, effectively making the mag well smaller thru its entire length. No sense modifying all these to fit what may be a standard non-standard grip.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Please consider becoming an UZI Talk Supporter.