UZI Talk Forums
+ Reply to Thread
Results 1 to 3 of 3

Thread: Benelli M4 Magazine Cap

  1. #1
    Registered User
    Join Date
    Apr 2009
    Location
    Ohio
    Posts
    221

    Benelli M4 Magazine Cap

    Does anyone know the thread used on the Benelli M4 magazine tube and magazine end cap? I can tell that it's metric, but that's about all I can tell.

    Thanks!!

  2. #2
    Registered User
    Join Date
    Jun 2021
    Posts
    1
    Hi, not sure if you seen this post from the Benelli forums, but this is what someone over there measured the tube as being. Might not help at all, but I remembered seeing it before.

    "The*factory full length tube I have here looks to have a nominal 1.00" O.D. tube with a square thread of 2mm pitch. The crest seems to be 0.9mm (.035"), the root seems to be*1.1mm (.043") and the thread depth of 0.4mm. Again a shallow thread that is covered with a rough parkerization, so those*measurements*are as close as I can figure for now."

  3. #3
    Registered User
    Join Date
    Apr 2009
    Location
    Ohio
    Posts
    221
    Quote Originally Posted by Big R View Post
    Hi, not sure if you seen this post from the Benelli forums
    No, I had not seen that. Thank you sir!!!

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Please consider becoming an UZI Talk Supporter.