UZI Talk Forums
+ Reply to Thread
Results 1 to 8 of 8

Thread: Source for M11A1 AKA "M12" Lower for Post Sample Sub Gun???

  1. #1
    Registered User
    Join Date
    May 2013
    Location
    Western Pa
    Posts
    12

    Source for M11A1 AKA "M12" Lower for Post Sample Sub Gun???

    Hi, I am a 07 Manufacturer with a SOT. I have one of the Heavy M11A1 Bolts(CF-W 9MMA) but no M11. I would like to make a M11, not M11/9mm, 9x19 Sample Gun for shits & giggles. I do understand it's probably totally impractical. Do I start with one of the leinad lowers & go from there? Or, is it better to fold a flat? And, what mag well & mags to use? Thanks very much!
    Last edited by alnukem; 06-21-2021 at 07:04 PM.

  2. #2
    UZI Talk Supporter
    Gaujo's Avatar
    Join Date
    Sep 2013
    Location
    Raleigh, NC
    Posts
    3,293
    Assuming this is a legit RPB flat this would seem to be a good place to start as they made real original ones.
    https://www.ftfindustries.com/produc...11380FLAT.html

  3. #3
    Registered User timgunfreak's Avatar
    Join Date
    Jun 2004
    Location
    Australia
    Posts
    227

  4. #4
    Registered User Shattered's Avatar
    Join Date
    Oct 2007
    Location
    North Coast
    Posts
    2,246
    Ummm…he did say 9mm…

  5. #5
    UZI Talk Supporter
    Offmarksman's Avatar
    Join Date
    Sep 2010
    Posts
    622
    If the “heavy” bolt he has is a CFW-A bolt. 9mm out of the .380 gun is doable. Just need to swap the barrel. They perform flawlessly in my baby Macs.

  6. #6
    Registered User
    Join Date
    May 2013
    Location
    Western Pa
    Posts
    12
    Hi, Thanks for your input. I dug out the bolt, it is engraved CF-W 9MMA. It weighs a little over 25 ounces. The rear of the recoil spring is red paint maked. I take it you just shorten a M11/9mm Upper?

  7. #7
    UZI Talk Supporter
    Offmarksman's Avatar
    Join Date
    Sep 2010
    Posts
    622
    You can cut down a m11/9 or buy a M11 or M12 (.380) upper remove the .380 barrel and replace with a 9mm m11/9 barrel

  8. #8
    Registered User
    Join Date
    May 2013
    Location
    Western Pa
    Posts
    12
    Hi, I think I'm going to order flats from here.

    https://www.leetoolandmachine.com/m10-m11.html

    Is that a good choice? It seems they were a OEM to SWD.

    Is this what I need to bend them, or is there a better choice?

    https://www.gunbroker.com/item/903597021

    Thank you guys for your help!

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Please consider becoming an UZI Talk Supporter.