Search results

look under general references on front page of this website https://www.uzitalk.com/reference/pages/FAconversions_mini.htm

the Tom Denall Ruger 44mag Silent Destroyer has the factory barrel cut to 9". The inner tuber is then permanently affixed to the 9" original barrel and holds the baffle and spacer stack with slots in front of baffles for gas to enter the coaxial space. An escentric outer tube with a large...

here is another a little higher priced https://www.precisiondelta.com/products/9mm-147gr-fmj/

i have bought and loaded literally 1000's of these 147 grain round nose 9mm. https://www.rozedist.com/mm5/merchant.mvc?Screen=PROD&Store_Code=RZD&Product_Code=R152-A&Category_Code=ZBJ-9MM

if folks are receiving Micro barrels now maybe I will be seeing a couple soon--Yea!

i'll take 2.

(1) Micro 5.25" ported---9mm (1) Micro 4.5" Plain---9mm Email sent

read and download all the stuff on samachine.com about mags, lock-up (about a dime's thickness under the ejector) , and troubleshooting, also the MGN article Sept 1993 "Performance Surgery for the MK760" is good if you can find it. If mags can move forard or backward at lockup do not pull back...

are you needing some specific dimensions???

look here---these guys do it https://www.accuracysystems.com/

I though Richard @ BWE does weld ups on worn MK760 sears.

sounds like if he is waiting on eforms there must be some type of registration (MG/SBR??) that he did not mention in the original post. IF it is F/A then the extra 10.5 threaded barrel is moot.

And I thought $500 was bad when I bought C&S' last SW76 drum back in the day. When they started doing drums an MP5 drum was $350. How would have thought.

i full length size and deprime on single stage(with carbine sizer) then clean brass, before going to load on dillon and do not use station #1 anymore.

top covers for uzi pistol/micro pop up infrequently. watch gunbroker--us barrel shroud--gun parts corp type websites daily. have funds ready to buy immediately. was one on gunbroker about 3 weeks ago. also can do WTB ad on various boards in search of somebody with an extra they'll part with...

strobo32, what cu ft is your tank and did you have it hydrostatically tested before building? do you plan on during a hydro every 5 years same as in scuba diving? how much pressure do you use in discharge tank? is it CO2 same as paintball?

i used some thin flashing I already had rather than purchasing shim stock. I applied the silicone oil inside the outer tube then inserted the flashing with very little overlap. the silicone oil seems to hold the flashing flush to the outer tube pretty good without needing the gas pressure to aid...

he completed the project and had springs for sale. I assume he still sells springs.

https://www.snipershide.com/shooting/threads/223-5-56mm-load-data-77gr-smk.31521/

there's a few 69 grain loadings on reloadammo dot com